Get an OBDII smart phone/tablet App and interface, typically $30 or less. Get a quote and book an appointment online or speak to a service advisor at 1-80.PA Soft/BMW Scanner 1.4.0 is the WRONG tool for driveability issues. YourMechanic offers certified mobile mechanics who will come to your home or office to diagnose and repair your vehicle. In some cases, cleaning the sensor will resolve the issue and not require replacement. This is a specific cleaner that is the only cleaner that should be used on the MAF sensor. These cleaners are added to the intake or gas tank and used to clean the varnish out of the fuel system.īefore you replace the mass air flow sensor, know that it can be cleaned using mass air flow sensor cleaner.
This may be resolved with the use of fuel system cleaners. In some scenarios, a clogged fuel injector or low fuel pressure is present.
Notes all codes and the freeze frame data associate with them Hooks up the scan tool and checks for any code stored in the ECU How does a mechanic diagnose the P2177 code?įollowing these simple steps, a technician will diagnose the P2177 code:
Check Engine Light illuminated on the dashboard.With that, the symptoms can vary greatly depending on what is causing the code: Faulty readings from the oxygen sensorsĪ wide array of causes can trigger the P2177 code.What causes the P2177 code?Ī multitude of items can cause the P2177 code: The failsafe mode will remain on until normal operation is detected or the code is repaired. This failsafe mode is enabled to protect the engine from damage and sets a fixed air-fuel ratio to prevent the vehicle from becoming too rich or too lean. With the Check Engine Light, a failsafe mode is set. The engine control module (ECM) constantly monitors the air-fuel ratio, and when it is found to be too lean off idle for bank 1, the Check Engine Light is set, which can be seen on the dashboard. What that tells us is that the air-fuel mixture is too lean for the bank 1 half of the engine. The P2177 code means that the system is too lean off idle for bank 1. This code may be seen with other lean condition codes or misfire codes. P2177 is a general OBD-II diagnostic trouble code indicating a fault with the bank 1 too lean.